Kenmore Elite Dryer Error Codes

Modern dryers, like the Kenmore Elite HE3, have digital displays that show error messages when there's a problem with a component or a part has failed. Below is a diagnosis of the error codes that might appear on your dryer:

This error signifies a power failure during the dryer cycle. Press the Stop button to clear the display. If you experience frequent power failures with your dryer, check the electrical outlet cord. Replacement parts, if needed, include the Outlet Cord.

This error indicates that the main electronic control board has failed. Remove power from the dryer for 10 minutes, then restore power. If the error code returns, replace the main electronic control board.

If a button on the keypad is stuck on one of the user interface controls, you'll see this error code. If the button cannot be unstuck, replace the user interface control assembly.

This error suggests that the heater relay on the main electronic control board has failed. Power down the dryer and replace the main electronic control board.

These error codes indicate an electrically open outlet temperature sensor (thermistor). Power down the dryer, use a multimeter, and check the resistance of the thermistor/temp sensor (10,000 ohms). Replace it if it's faulty.

These codes signify an electrically open or shorted inlet temperature sensor (thermistor). Power down the dryer, use a multimeter, and check the resistance of the thermistor/temp sensor (50,000 ohms). Replace it if it's faulty. Note: the inlet thermistor is part of the high limit thermostat on this dryer.

These error codes suggest a problem with the moisture sensor. Power down the dryer and check the wiring harness on the moisture sensor both visually and with a multimeter. Replace the moisture sensor if necessary.

This error code suggests restricted outlet airflow. Clean any lint from the lint screen filter, remove fabric softener buildup on the lint screen if necessary, and clear any lint blockage from the air vent exhaust system.

This error code indicates that the L2 leg of the 240-volt power is below 30 volts. Check and reset the circuit breakers for the dryer if necessary. Remove power from the dryer and then check the power cord wire connections on the terminal. Replace the power cord if it is damaged. Check the 240-volt power supply to the dryer.

This error signifies a lack of communication between the electronic control board (ECB) and the user interface control board assembly (UICB). Remove power from the dryer, and check the wire harnesses between the ECB and the UICB both visually and with a multimeter. If the connections are okay, you may need to replace the main electronic control board and the user interface control assemblies.

These error codes indicate a failure with the user interface control assembly. Remove power from the dryer and check the wire harness connections between the user interface assemblies both visually and with a multimeter. Check the wire harness connections between the main electronic control board and the user interface assemblies visually and with a multimeter. If the wiring connections are okay, one or both of the user interface control assemblies may need to be replaced.