crwdns2935355:0devicecrwdnd2935355:0crwdnd2935355:0crwdne2935355:0
crwdns2935335:0crwdne2935335:0
crwdns2935381:0crwdne2935381:0
crwdns2936071:01crwdne2936071:0
Put the unit upside down and take off the rubber bottom cover. It is better to start at a corner.
crwdns2936071:02crwdne2936071:0
Remove the # 10 Phillips # 00 screws that hold the Time Capsule's lower metal bracket.
crwdns2936071:03crwdne2936071:0
With the tip of a spudger carefully remove the fan connector then remove the metal bottom cover.
crwdns2936071:04crwdne2936071:0
Find the temperature sensor on the surface of the hard disk.
crwdns2936071:05crwdne2936071:0
Remove the clip that holds the temperature sensor and remove both.
crwdns2936071:06crwdne2936071:0
Lift the hard drive a bit without pulling too hard to not cause damage to the power and data connectors of the hard disk. Removing the power connector from the hard drive
crwdns2936071:07crwdne2936071:0
Once we have the disc out of the Time Capsule, we remove the 4 Phillips head # 00 pillars and place them in the new unit.
crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0