SwagTron T1 Wheel Replacement

crwdns2935421:0crwdne2935421:0 crwdns2935423:0crwdne2935423:0

crwdns2935425:02crwdne2935425:0

crwdns2935419:0crwdne2935419:0

crwdns2936315:0crwdne2936315:0

crwdns2936323:0crwdne2936323:0

crwdns2931653:02crwdne2931653:0

SwagTron T1 Wheel Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0

SwagTron T1 Wheel Replacement: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0

SwagTron T1 Wheel Replacement: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0

Using your H 6.0 allen wrench, remove the four 20mm black bolts shown in the picture.
Take off the iron plate holding the wheel in place.
Remove the Motor/Wheel and set it aside close by to the hoverboard.
The wires from the Motor/Wheel should still be connected to the motherboard.
These bolts are very tight, it may be difficult to remove them. Try using a tool with a long handle.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0