iRobot Roomba 880 Bumper Sensors Replacement

crwdns2935425:011crwdne2935425:0

crwdns2936315:0crwdne2936315:0

crwdns2936325:0crwdne2936325:0

crwdns2931653:011crwdne2931653:0

Remove the 6 bumper sensors from the side of your device.
This will require some tugging as the sensors are securely situated in the device currently. We recommend using a spudger if they are particularly difficult.
You might need to cut the tape that is currently holding several sets of bumper sensor wires together. It might be helpful to tape the new sensor wires back together when putting your device back together.
As you can see in the third photo the cable from the bumper sensor was originally connected to the motherboard.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0