crwdns2933423:0crwdne2933423:0

Ersa i-CON 1 soldeerstation display achtergrond verlichting LED's vervanging

crwdns2936315:0crwdne2936315:0
crwdns2936313:0crwdne2936313:0
crwdns2931653:05crwdne2931653:0
Ersa i-CON 1 soldering station display backlight replacement, Desolder original backlight LEDs: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0
Desolder original backlight LEDs
  • Fold the circuit strip onto the back cover of the display and weigh it down. This will expose the faulty original LEDs and some resistors.

  • Before soldering, place heat-resistant material under the strip to prevent damage to the display's plastic back cover. If the plastic melts, it can cause unsightly spots. In the photo, several sheets of paper are used.

Vouw de circuitstrip op de achterkant van het display en verzwaar deze. Dit zal de defecte originele LED's en enkele weerstanden onthullen.

Leg voor het solderen wat hittebestendig materiaal onder de strip. Als je de plastic achterkant van het scherm smelt, ontstaan er lelijke plekken. Ik gebruik verschillende vellen papier op de foto.

[title] Desolder original backlight LEDs
-[* black] Fold the circuit strip onto display's back cover and weigh it down. This will reveal the faulty original LEDs and some resistors.
-[* icon_caution] Place some heat-resistant material under the strip before soldering. If you melt display's plastic back cover, it will develop unsightly spots. I'm using several sheets of paper in the photo.
+[* black] Fold the circuit strip onto the back cover of the display and weigh it down. This will expose the faulty original LEDs and some resistors.
+[* icon_caution] Before soldering, place heat-resistant material under the strip to prevent damage to the display's plastic back cover. If the plastic melts, it can cause unsightly spots. In the photo, several sheets of paper are used.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0