crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

Ersa i-CON 1 soldeerstation display achtergrond verlichting LED's vervanging

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936313:0crwdne2936313:0
crwdns2931653:04crwdne2931653:0
Ersa i-CON 1 soldering station display backlight replacement, Unstick the circuit strip from the base: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0
Unstick the circuit strip from the base

  • Use a knife or similar tool to carefully unstick the circuit strip from the plexiglass base.

  • The strip is held in place with a thin, transparent, double-sided tape. Be sure to keep the tape on the plexiglass base as you remove the strip. If the tape tears away with the strip, use the tip of the knife to push it back onto the plexiglass.

  • Try to bend the strip as little as possible to make it easier to seat back in properly later.

Maak de circuitstrip los van de basis

Maak de circuitstrip voorzichtig los van de plexiglas basis met een mes.

De strip is vastgelijmd met een dunne transparante dubbelzijdige tape. Zorg ervoor dat de tape op de plexiglas basis blijft zitten. Als het samen met de strip wegscheurt, gebruik dan de punt van het mes om het terug op het plexiglas te duwen.

Probeer de strip zo weinig mogelijk te buigen, anders is het moeilijk om hem later goed terug te plaatsen.

[title] Unstick the circuit strip from the base
-[* black] Carefully unstick the circuit strip from the plexiglass base with knife.
-[* black] The strip is glued in with a thin transparent double-sided tape. Make sure the tape stays on the plexiglass base. If it tears away along with the strip, use knife tip to push it back onto the plexiglass.
-[* icon_caution] Try to bend the strip as little as possible, otherwise it will be difficult to seat it back in properly later.
+[* black] Use a knife or similar tool to carefully unstick the circuit strip from the plexiglass base.
+[* black] The strip is held in place with a thin, transparent, double-sided tape. Be sure to keep the tape on the plexiglass base as you remove the strip. If the tape tears away with the strip, use the tip of the knife to push it back onto the plexiglass.
+[* icon_note] Try to bend the strip as little as possible to make it easier to seat back in properly later.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0