crwdns2933423:0crwdne2933423:0

iMac Intel 21.5" Retina 4Kディスプレイの接着ストリップの交換

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:03crwdnd2931529:0crwdne2931529:0

crwdns2936315:0crwdne2936315:0
crwdns2936323:0crwdne2936323:0
crwdns2931653:014crwdne2931653:0
iMac Intel 21.5" Retina 4K Display Adhesive Strips Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 iMac Intel 21.5" Retina 4K Display Adhesive Strips Replacement: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
  • At this point it's a good idea to test your repair, in order to make sure your iMac works properly before you seal it back up. Follow the next three steps to temporarily reconnect the display cables and boot up your iMac prior to pulling the protective film off the adhesive strips.

  • If you've already verified that your iMac is working correctly and are ready to seal it up, skip to Step 17.

  • Insert the display power cable into its socket on the logic board.

この時点で、iMacディスプレイを閉口する前に、正しく稼働するかどうかテストする良い機会です。次の3つの手順では一時的にディスプレイケーブルを接続してiMacを立ち上げて点検してください。点検が終わったら各接着ストリップ裏の保護フィルムを剥がします。

iMacが正しく稼働かどうか点検が終了して、すでにディスプレイを閉口している場合は、手順17までスキップしてください

ディスプレイのパワーケーブルを基板上のソケットに差し込みます。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0