crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

VTech Write and Learn Creative Center Speaker Replacement

crwdns2931527:0crwdnd2931527:0crwdnd2931527:0crwdnd2931527:0crwdne2931527:0

crwdns2935423:0crwdne2935423:0

crwdns2935425:01crwdne2935425:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936325:0crwdne2936325:0
crwdns2931653:01crwdne2931653:0
VTech Write and Learn Creative Center Speaker Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 VTech Write and Learn Creative Center Speaker Replacement: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 VTech Write and Learn Creative Center Speaker Replacement: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0

  • In order to remove the speaker, you must desolder the two wires connecting it to the circuit board.

  • When you desolder, apply the tip of the soldering iron to the soldered joint for approximately 5 - 10 seconds.

  • The soldered joint will turn to a liquid consistency. At this moment, remove the wire and soldering iron.

  • Repeat each of the following steps for the second soldered joint.

  • Soldering irons are dangerously hot. The soldering iron should only come in contact with joints being desoldered or soldered.

  • Make sure to allow time for your soldering iron to heat up before using it.

  • Make sure the tip of the soldering iron is cleaned so the tin on the tip is exposed. This will allow the soldering iron to work efficiently.

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0