crwdns2933423:0crwdne2933423:0

How to reduce ChiliCube noise level by replacing fans

crwdns2936315:0crwdne2936315:0
crwdns2936321:0crwdne2936321:0
crwdns2931653:012crwdne2931653:0
How to reduce ChiliCube noise level by replacing fans, Attach fan so 3-way switch will reach: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 How to reduce ChiliCube noise level by replacing fans, Attach fan so 3-way switch will reach: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
Attach fan so 3-way switch will reach
  • If you do go with the 3-speed fan used here, look ahead in instructions to see where the switch gets positioned, then attach fan appropriately to the bracket/shroud plate.

  • Note direction fan is attached. The side with cable lead-in to motor, (and usually the only label or fancier of the two hub labels), that side faces inward towards the heat sink, and the bracket/shroud plate.

  • Don't freak out if you think you can't fish the cable through the shroud the right way. You can pass the whole fan through the shroud hole on the 45º.

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0