crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

Remplacement du boitier arrière du Palm Zire 71

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:02crwdnd2931529:0crwdne2931529:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936317:0crwdne2936317:0
crwdns2931653:04crwdne2931653:0
Palm Zire 71 Back Cover Replacement, Front Panel Removal: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 Palm Zire 71 Back Cover Replacement, Front Panel Removal: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
Front Panel Removal

  • Flip the device over so it's facing screen-side up.

  • Slide the screen upward by a few millimeters without detaching the screen - just enough to expose the top edge of the metallic panel so that you can reach underneath.

  • Avoid pulling up too far - there's a fragile ribbon cable underneath the panel!

  • Use the plastic opening tool to pry off the front panel.

  • This part is tricky, especially if you want to avoid damaging the panel. Opening picks are quite handy here; try inserting them in the seam at the bottom of the device, and working them around. You may also find it helpful to squeeze the sides of the device to release the sides of the front panel.

crwdns2935429:0crwdne2935429:0

Retournez pour voir la face avant.

Faites glisser l'écran vers le haut un peu plus haut SANS détacher l'écran.

Utilisez l'outil d'ouverture en plastique pour soulever le panneau avant.

-[* black] Turn to the frontside
-[* icon_caution] Slide the screen upward a little higher WITHOUT detaching the screen
-[* red] Use the plastic opening tool to pry off the front panel
+[title] Front Panel Removal
+[* black] Flip the device over so it's facing screen-side up.
+[* black] Slide the screen upward by a few millimeters without detaching the screen - just enough to expose the top edge of the metallic panel so that you can reach underneath.
+ [* icon_caution] Avoid pulling up too far - there's a fragile ribbon cable underneath the panel!
+[* red] Use the plastic opening tool to pry off the front panel.
+ [* icon_caution] This part is tricky, especially if you want to avoid damaging the panel. Opening picks are quite handy here; try inserting them in the seam at the bottom of the device, and working them around. You may also find it helpful to squeeze the sides of the device to release the sides of the front panel.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0