crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

Reemplazo del sensor de nariz Zoomer Dino Boomer

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936331:0crwdne2936331:0
crwdns2931653:05crwdne2931653:0
Zoomer Dino Boomer Nose Sensor Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Zoomer Dino Boomer Nose Sensor Replacement: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Zoomer Dino Boomer Nose Sensor Replacement: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0

  • Use a soldering iron to remove the wires from the sensor chip by melting the metal joints on the chip.

  • Use the tweezers to remove the wires as you are soldering them.

  • Do not touch any parts of Zoomer Dino Boomer or yourself when using the soldering iron. The soldering iron will be very hot.

  • When reassembling, extra solder may be required to reconnect the wires with the circuit board.

Utiliza un soldador para quitar los cables del chip del sensor derritiendo las juntas metálicas del chip.

Utiliza las pinzas para quitar los cables mientras los suelda.

No toques ninguna parte de Zoomer Dino Boomer ni a ti mismo cuando utilices el soldador. El soldador estará muy caliente.

Al volver a ensamblar, es posible que se requiera soldadura adicional para volver a conectar los cables con la placa de circuito.

[* red] Use a soldering iron to remove the wires from the sensor chip by melting the metal joints on the chip.
-[* black] Use the tweezers to remove the wires as you are soldering them.
+[* black] Use the [product|IF145-020|tweezers] to remove the wires as you are soldering them.
[* icon_caution] Do not touch any parts of Zoomer Dino Boomer or yourself when using the soldering iron. The soldering iron will be very hot.
[* icon_reminder] When reassembling, extra solder may be required to reconnect the wires with the circuit board.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0