crwdns2894164:0crwdne2894164:0

crwdns2876698:0crwdnd2876698:0crwdnd2876698:0crwdnd2876698:02crwdnd2876698:0crwdne2876698:0

crwdns2876889:0crwdne2876889:0
crwdns2876898:0crwdne2876898:0
crwdns2894314:026crwdne2894314:0
Slide a plastic card underneath the center of the logic board, pushing it in as far as it will go. Slowly swing the left edge of the logic board up, while making sure it doesn't snag against any of the disconnected cables.
  • Slide a plastic card underneath the center of the logic board, pushing it in as far as it will go.

  • Slowly swing the left edge of the logic board up, while making sure it doesn't snag against any of the disconnected cables.

  • If any portion of the logic board requires excessive force to pry up, stop prying, re-apply the iOpener, and re-perform the corresponding guide steps to fully release the adhesive.

Desliza una tarjeta de plástico debajo del centro de la placa lógica, empujándola hasta el tope.

Mueve lentamente el borde izquierdo de la placa lógica hacia arriba, mientras te aseguras de que no se enganche con ninguno de los cables desconectados.

Si alguna parte de la placa lógica requiere una fuerza excesiva para levantar, deja de hacer palanca, vuelve a aplicar el iOpener y vuelve a realizar los pasos de guía correspondientes para liberar completamente el adhesivo.

crwdns2859191:0crwdnd2859191:0crwdnd2859191:0crwdnd2859191:0crwdne2859191:0