crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

MacBook Pro (13 Zoll, Mitte 2010, Unibody) optisches Laufwerk Austausch

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:04crwdnd2931529:0crwdne2931529:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936319:0crwdne2936319:0
crwdns2931653:02crwdne2931653:0
MacBook Pro 13" Unibody Mid 2010 Optical Drive Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0

  • It will be necessary to slide the small clear plastic cable retainer (boxed in red) glued to the logic board out of the way before disconnecting the camera cable. Be careful not to break any components off the board as you slide it away from the camera cable connector.

  • Pull the camera cable connector toward the optical drive to disconnect it from the logic board.

  • This socket is metal and can be easily bent. Be sure to align the connector with its socket on the logic board before mating the two pieces.

Du musst einen kleinen durchsichtigen Plastikkabelhalter (im Bild rot markiert), der am Logic Board festgeklebt ist, aus dem Weg schieben, bevor du das Kamerakabel lösen kannst. Passe dabei auf, dass du keine Bauteile beschädigst.

Ziehe den Verbinder des Kamerakabels in Richtung des optischen Laufwerks, um es vom Logic Board zu lösen.

Dieser Sockel ist aus Metall und kann leicht verbogen werden. Passe auf, dass du den Verbinder gerade im Sockel ausrichtest, wenn du die beiden Teile zusammenfügst.

[* icon_caution] It will be necessary to slide the small clear plastic cable retainer (boxed in red) glued to the logic board out of the way before disconnecting the camera cable. Be careful not to break any components off the board as you slide it away from the camera cable connector.
[* black] Pull the camera cable connector toward the optical drive to disconnect it from the logic board.
-[* icon_note] This socket is metal and easily bent. Be sure to align the connector with its socket on the logic board before mating the two pieces.
+[* icon_note] This socket is metal and can be easily bent. Be sure to align the connector with its socket on the logic board before mating the two pieces.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0