crwdns2933423:0crwdne2933423:0

Remplacement de l'écran LCD du Olympus Stylus Tough-8010

crwdns2935425:01crwdne2935425:0

crwdns2936315:0crwdne2936315:0
crwdns2936317:0crwdne2936317:0
crwdns2931653:01crwdne2931653:0
Olympus Stylus Tough-8010 LCD Screen Component Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0
  • Remove all the tape and clear rubber material from the components.

  • Remove two screws (4.1mm) using a #000 Phillips head screwdriver on the left side of the lcd component.

  • Make sure to set aside the two metal pieces that come off after the screws are removed.

  • Using the tweezers disconnect the plastic ribbon from the connector on the control board by lifting the small black flap on the connector and pulling on the ribbon.

Retirez tout le ruban adhésif et le caoutchouc transparent des composants.

Retirez deux vis (4,1 mm) à l'aide d'un tournevis cruciforme n ° 000 sur le côté gauche du composant LCD.

Assurez-vous de mettre de côté les deux pièces métalliques qui se détachent après le retrait des vis.

À l'aide de la pince à épiler, déconnectez le ruban en plastique du connecteur de la carte de commande en soulevant le petit rabat noir du connecteur et en tirant sur le ruban.

[* black] Remove all the tape and clear rubber material from the components.
[* red] Remove two screws (4.1mm) using a #000 Phillips head screwdriver on the left side of the lcd component.
[* icon_note] Make sure to set aside the two metal pieces that come off after the screws are removed.
-[* orange] Using the tweezers disconnect the plastic ribbon from the connector on the control board by lifting the small black flap on the connector and pulling on the ribbon.
+[* orange] Using the [product|IF145-020|tweezers] disconnect the plastic ribbon from the connector on the control board by lifting the small black flap on the connector and pulling on the ribbon.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0