crwdns2933423:0crwdne2933423:0

Luz amarilla de la muerte (LADM) (YLOD)

crwdns2936315:0crwdne2936315:0
crwdns2936331:0crwdne2936331:0
crwdns2931653:03crwdne2931653:0
Yellow Light of Death Repair: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0
  • Set the heat gun to "Low" or around 300C (575F), and let it run for a few seconds to reach operating temperature.

  • Holding the motherboard upright, warm up the entire board with the heat gun. The board should be warm, but not too hot.

  • This will prevent damage to the board caused by localized thermal expansion.

Configura la pistola de calor en "Bajo" o alrededor de 300C (575F) y déjala funcionar durante unos segundos para alcanzar la temperatura de funcionamiento.

Sosteniendo la placa base en posición vertical, calienta toda la placa con la pistola de calor. El tablero debe estar tibio, pero no demasiado caliente.

Esto evitará daños a la placa causados ​​por la expansión térmica localizada.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0