crwdns2933423:0crwdne2933423:0

Xbox 360 HDD tauschen

crwdns2935425:01crwdne2935425:0

crwdns2936315:0crwdne2936315:0
crwdns2936319:0crwdne2936319:0
crwdns2931653:01crwdne2931653:0
Xbox 360 HDD Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Xbox 360 HDD Replacement: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Xbox 360 HDD Replacement: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
  • Here it is. The standard 20GB HDD for the Xbox 360.

  • Notice the proprietary adapter. Inside is just a pretty standard 2.5" SATA drive...

  • I took these pictures as I was putting it back together, hence the Microsoft warranty sticker looking a little funny.

  • You may also notice the screw in the bottom left is partly out. This is because as I was replacing the screw before it, I broke my bit. I was using a 1/16" flathead bit (I don't have a T6 Torx) and used just a little too much torque and it snapped. I found another 1/16" bit to finish, but didn't get a pic.

  • If you have Torx bits/drivers, use them. They will work much better than the flatheads.

Hier ist sie. Die originale 20GB HDD für die Xbox 360.

Beachte den proprietären Adapter. Im Inneren befindet sich nur eine ziemlich normale 2,5-Zoll-SATA-Festplatte...

Ich habe diese Bilder gemacht, als ich die Xbox wieder zusammengebaut habe, deshalb sieht der Microsoft-Garantiesticker etwas komisch aus.

Eventuell stellst du fest, dass die Schraube unten links teilweise herausgedreht ist. Das liegt daran, dass mir beim Auswechseln der Schraube zuvor mein Bit abgebrochen ist. Ich habe etwas zu kräftig den falschen Bit verwendet, wodurch er abgebrochen ist. Ich habe einen neuen 1/16-Zoll-Bit gefunden, jedoch kein neues Bild gemacht.

Wenn du einen Torx-Bit oder einen Torx-Schraubendreher hast, verwenden ihn. Das sollte deutlich besser klappen als ein Schlitzbit.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0