crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

DYMO LabelPOINT 100 sostituzione della tastiera

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936321:0crwdne2936321:0
crwdns2931653:04crwdne2931653:0
DYMO LabelPOINT 100 Keypad Replacement, Removing Circuit Board: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 DYMO LabelPOINT 100 Keypad Replacement, Removing Circuit Board: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
Removing Circuit Board

  • Use Phillips #00 Screwdriver to remove three screws that hold down the circuit board.

  • Gently lift the bottom of the circuit board, revealing the keypad.

  • Be careful not to damage any components on the circuit board when disassembling.

Rimuovere il circuito

Usare il cacciavite Philips #00 per rimuovere le tre viti che mantengono il circuito stampato.

Dopo aver rimosso con cautela il circuito, si avrà accesso alla tastiera.

Stai attento a non danneggiare alcun componente durante lo smontaggio.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0