crwdns2933423:0crwdne2933423:0

认识和断开线缆连接头

crwdns2936315:0crwdne2936315:0
crwdns2936311:0crwdne2936311:0
crwdns2931653:05crwdne2931653:0
Recognizing & Disconnecting Cable Connectors, Flat-Topped (Low Profile) Connectors: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Recognizing & Disconnecting Cable Connectors, Flat-Topped (Low Profile) Connectors: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Recognizing & Disconnecting Cable Connectors, Flat-Topped (Low Profile) Connectors: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Flat-Topped (Low Profile) Connectors
  • Some connectors have a flat, plastic top that sits flush on top of their socket. Often, these connectors have multiple cables connected to them. Flat-topped connectors are usually on the larger side, and are typically used to connect batteries in laptops and larger gaming devices.

  • To disconnect the cable, use the flat end of a spudger to lift and unclip the outer edges of the connector. You may need to use your fingers to pull the connector completely out of its socket.

  • Sometimes, these connectors have a slide lock running across the top that holds the connector in place. If this is the case, push the lock away from the connector before trying to disconnect it.

  • Flat topped connectors can also have a metal locking bar that keeps the connector in place. Unclip and flip the locking bar up to disconnect it.

  • To reconnect the cable, carefully position the connector over its socket and press straight down—the connector should snap into place without much force. If you're having trouble, the connector is most likely misaligned. Reposition it and try again.

  • Don't try to force the connector into place or you may damage the delicate pins.

一些连接器有一个平坦的塑料顶部,与插座顶部齐平。通常,这些连接器连接了多根电缆。平顶连接器通常偏大,通常用于连接笔记本电脑和大型游戏设备的电池。

要断开电缆,请使用撬棒的扁平端提起并松开连接器的外边缘。您可能需要用手指将连接器完全从插座中拉出。

有时,这些连接器的顶部有一个滑锁,用于将连接器固定到位。如果是这种情况,请在尝试断开锁之前将锁从连接器上推开。

平顶连接器还可以有一个金属锁定杆,用于将连接器固定到位。 松开并向上翻转锁定杆以断开连接。

要重新连接电缆,请小心地将连接器放在其插座上,然后垂直向下按压 - 连接器应无需用力即可卡入到位。如果您遇到问题,则连接器很可能未对准。重新定位它,然后重试。

请勿尝试强行将连接器固定到位,否则可能会损坏精密的针脚。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0