crwdns2933423:0crwdne2933423:0

핸드 프레스를 사용한 금속 스냅 부착

crwdns2936315:0crwdne2936315:0
crwdns2936325:0crwdne2936325:0
crwdns2931653:014crwdne2931653:0
Metal Snap Installation Using a Hand Press, Install the snap head: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Metal Snap Installation Using a Hand Press, Install the snap head: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Metal Snap Installation Using a Hand Press, Install the snap head: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Install the snap head
  • Lay the item to be repaired into the hand press so that the hole from the original snap rests directly above the shaft of the post.

  • If the fabric around the old snap is torn or damaged beyond a small hole, apply a patch to reinforce the area before replacing the snap.

  • Make sure no extra fabric is caught inside the press and that the orientation of the item is correct.

  • Hold the fabric in place with one hand, then use your other hand to pull down the handle of the press.

  • This requires a lot of pressure to make sure the snap replacement is successful - so pull hard!

기존 스냅의 구멍이 포스트의 축 바로 위에 놓이도록 수리할 대상을 핸드 프레스에 놓으세요.

기존 스냅 주변의 천이 찢어지거나 작은 구멍보다 크게 손상된 경우 스냅을 교체하기 전에 패치를 덧대어 해당 부분을 보강하세요.

프레스 내부에 여분의 천이 끼지 않았는지, 수리할 대상의 방향이 올바른지 확인하세요.

한 손으로 천을 제자리에 고정하고 다른 손으로 프레스의 손잡이를 아래로 당깁니다.

스냅 교체가 성공적으로 이루어지려면 많은 압력이 필요하므로 세게 당기세요.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0