crwdns2933423:0crwdne2933423:0

使用手动压扣机安装金属按扣

crwdns2936315:0crwdne2936315:0
crwdns2936311:0crwdne2936311:0
crwdns2931653:07crwdne2931653:0
Metal Snap Installation Using a Hand Press, Install the snap base: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Metal Snap Installation Using a Hand Press, Install the snap base: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Metal Snap Installation Using a Hand Press, Install the snap base: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Install the snap base
  • Lay the item to be repaired into the hand press so that the hole from the original snap rests directly above the shaft of the post.

  • If the fabric around the old snap is torn or damaged beyond a small hole, apply a patch to reinforce the area before replacing the snap.

  • Make sure no extra fabric is caught inside the press and that the orientation of the item is correct.

  • Hold the fabric in place with one hand, then use your other hand to pull down the handle of the press.

  • This requires a lot of pressure to make sure the snap replacement is successful - so pull hard!

将待修复物品平放在手动压扣机上,使原有按扣的孔洞直接对准扣柱的轴部。

若旧按扣周围面料存在超出小孔范围的撕裂或损坏,需先在该区域缝制加固补丁再更换按扣。

确保没有多余面料被夹入压扣机,且物品方向正确。

单手固定面料位置,另一只手向下拉动压扣机手柄。

此步骤需要施加较大压力以确保按扣更换成功——请用力拉压!

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0