crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

ハンドプレスを使って金属製スナップ留めを付ける方法

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936323:0crwdne2936323:0
crwdns2931653:06crwdne2931653:0
Metal Snap Installation Using a Hand Press, Insert the stud die into the hand press: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Metal Snap Installation Using a Hand Press, Insert the stud die into the hand press: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Metal Snap Installation Using a Hand Press, Insert the stud die into the hand press: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Insert the stud die into the hand press

  • Using your fingers, a screwdriver, or a hex key, as needed, unscrew the tightening mechanism on the side of the press near the die fitting.

  • Insert the die upward and hold it in place.

  • Tighten the tightening mechanism.

crwdns2935429:0crwdne2935429:0

ハンドプレスの上側の接続金具ホルダーにスタッド接続金具をセットします。

スタッド接続金具には緑色の印が付いています。

接続金具の縁しか見えなくなるまで、接続金具を奥までしっかり入れます。

上側の接続金具ホルダーの横のねじをしっかりと締めスタッド接続金具を固定します。指で締めてからさらに90度まわして固く締めます。

-[* black] Insert the stud fitting into the upper fitting holder on the hand press.
- [* icon_note] The stud fitting is marked green.
-[* black] Insert the fitting as far as it will go, so that the only visible part is the wider encasement portion of the fitting.
-[* black] Tighten the screw on the side of the upper fitting holder to secure the stud fitting. Tighten the screw about a 1/4 turn past finger-tight.
+[title] Insert the stud die into the hand press
+[* red] Using your fingers, a screwdriver, or a hex key, as needed, unscrew the tightening mechanism on the side of the press near the die fitting.
+[* black] Insert the die upward and hold it in place.
+[* black] Tighten the tightening mechanism.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0