crwdns2933423:0crwdne2933423:0

Installare un bottone automatico in metallo utilizzando un torchietto

crwdns2936315:0crwdne2936315:0
crwdns2936321:0crwdne2936321:0
crwdns2931653:06crwdne2931653:0
Metal Snap Installation Using a Hand Press, Insert the stud die into the hand press: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Metal Snap Installation Using a Hand Press, Insert the stud die into the hand press: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Metal Snap Installation Using a Hand Press, Insert the stud die into the hand press: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Insert the stud die into the hand press
  • Using your fingers, a screwdriver, or a hex key, as needed, unscrew the tightening mechanism on the side of the press near the die fitting.

  • Insert the die upward and hold it in place.

  • Tighten the tightening mechanism.

Usando le dita, un cacciavite o una punta esagonale, se necessario, allenta il meccanismo per restringere che si trova dal lato del torchietto vicino alla giunzione del punzone.

Inserisci il punzone all'insù e tienilo fermo.

Riavvita il meccanismo per restringere.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0