crwdns2933423:0crwdne2933423:0

Metall-Druckknopf-Installation mit einer Handpresse

crwdns2936315:0crwdne2936315:0
crwdns2936319:0crwdne2936319:0
crwdns2931653:06crwdne2931653:0
Metal Snap Installation Using a Hand Press, Insert the stud die into the hand press: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Metal Snap Installation Using a Hand Press, Insert the stud die into the hand press: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Metal Snap Installation Using a Hand Press, Insert the stud die into the hand press: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Insert the stud die into the hand press
  • Using your fingers, a screwdriver, or a hex key, as needed, unscrew the tightening mechanism on the side of the press near the die fitting.

  • Insert the die upward and hold it in place.

  • Tighten the tightening mechanism.

Löse den Spannmechanismus an der Seite der Presse in der Nähe der Einsatzaufnahme – mit den Fingern, einem Schraubendreher oder einem Inbusschlüssel.

Führe den Einsatz von unten ein und halte ihn in Position.

Ziehe den Spannmechanismus fest.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0