crwdns2933423:0crwdne2933423:0

핸드 프레스를 사용한 플라스틱 스냅 부착

crwdns2936315:0crwdne2936315:0
crwdns2936325:0crwdne2936325:0
crwdns2931653:07crwdne2931653:0
Plastic Snap Installation Using a Hand Press, Set up the hand press: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Plastic Snap Installation Using a Hand Press, Set up the hand press: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Plastic Snap Installation Using a Hand Press, Set up the hand press: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Set up the hand press
  • Use your fingers, a screwdriver, or a hex key, as needed, to unscrew the tightening mechanism on the side of the press near the top die fitting.

  • Insert the die upward and hold it in place.

  • Tighten the tightening mechanism.

필요에 따라 손가락, 드라이버 또는 육각 렌치를 사용하여 상단 다이 피팅 근처의 프레스 측면에 있는 고정 메커니즘을 풀어주세요.

다이를 위쪽으로 끼우고 제자리에 고정하세요.

고정 메커니즘을 조이세요.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0