crwdns2933423:0crwdne2933423:0

핸드 프레스를 사용한 플라스틱 스냅 부착

crwdns2936315:0crwdne2936315:0
crwdns2936325:0crwdne2936325:0
crwdns2931653:06crwdne2931653:0
Plastic Snap Installation Using a Hand Press, Prepare the snap dies: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Plastic Snap Installation Using a Hand Press, Prepare the snap dies: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Plastic Snap Installation Using a Hand Press, Prepare the snap dies: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Prepare the snap dies
  • Place the cap die into the lower fitting of the hand press and drop the cap piece into the die, flat side down, so the plastic post is sticking upward.

  • Click the socket or stud piece into the corresponding die.

  • Patagonia Repair Tech Tip: The socket and stud dies look like the opposing snap so that the plastic piece will click right in.

캡 다이를 핸드 프레스의 하단 피팅에 놓고 캡의 플라스틱 포스트는 위를 향하고 평평한 면은 아래로 향하도록 캡을 다이에 넣으세요.

소켓 또는 스터드를 해당 다이에 끼우세요.

파타고니아 수리 기술 팁: 소켓과 스터드 다이는 정반대 스냅처럼 보이므로 플라스틱 부품이 바로 끼워집니다.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0