With a plastic spudger/pry bar, carefully go around the top end of the laptop where the screen meets the case, between the two hinges.

TIPS: When you get stuck at a section, you can use plastic spacers to hold the narrow gap of the case open while you readjust and start lifting another section.

Do not pull the panel up or forcibly remove the panel as you can break the panel and/or the attachments!

Do not use metal tools for this:

The battery is not disconnected yet and is inside the case, risk of electric shock and/or short circuit if you use metal tools.

Risk of panel, attachment or other kinds of aesthetic and functional damage to the case and components

Gently insert the spudger in the gap in the frame and begin to run the spudger along the length of this area of the laptop. If you're doing it correctly, you should begin to see/feel the case lifting away

Follow the steps above and continue around the outside of the case until you can lift the entire panel away, placing all screws into your project screw tray for safekeeping.