Doss E-GO II Speaker Driver Replacement

crwdns2935421:0crwdne2935421:0

crwdns2935425:02crwdne2935425:0

crwdns2935419:0crwdne2935419:0

crwdns2936315:0crwdne2936315:0

crwdns2936325:0crwdne2936325:0

crwdns2931653:02crwdne2931653:0

Doss E-GO II Speaker Driver Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0

Doss E-GO II Speaker Driver Replacement: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0

Doss E-GO II Speaker Driver Replacement: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0

Remove four 9.6 mm screws from one of the speaker drivers using the Phillips #00 screwdriver.
Gently flip the driver up away from you.
Apply a bead of flux. Press the soldering iron tip firmly to melt the solder.
If you heat the area for more than 10 seconds, the excessive heat may damage the wires.
Repeat for the other speaker driver if needed.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0