Shark ION RV754 Brush Roll Motor Replacement

crwdns2935425:01crwdne2935425:0

crwdns2936315:0crwdne2936315:0

crwdns2936311:0crwdne2936311:0

crwdns2931653:01crwdne2931653:0

Use a Phillips #1 screwdriver to remove the two 4.8 mm screws holding the brush roll motor.
Remove the wires attached to the clip by pulling them away gently.
For helpful tips on removing the cables from the board, take a look at the Recognizing and Disconnecting Cable Connectors guide.
Pull the brush roll motor up to remove it.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0