crwdns2933423:0crwdne2933423:0

縫わないファスナー修理の上級テクニック

crwdns2936315:0crwdne2936315:0
crwdns2936323:0crwdne2936323:0
crwdns2931653:08crwdne2931653:0
TECHNIQUE: Realigning an offset zipper
  • Issue - When zippers have been worn down, the sides of the zipper can become unaligned and offset. If the zipper is coil, the two sides can sometimes be realigned.

  • Technique - Bring the slider as close as possible to the unaligned area. Then move the slider away, gently pulling on the side of the zipper that's bubbled, trying to skip teeth. Bring the slider back down and repeat until the skipped area is fixed.

  • This technique is a permanent repair. However, if there's any hesitation that this technique will cause damage, remove and replace the slider.

問題点 - ファスナーが摩耗すると、ファスナーの両側がずれてオフセットすることがあります。ファスナーがコイルの場合、両側を再調整できることがあります。

テクニック - スライダーを、ずれている箇所にできるだけ近づけます。次に、スライダーを離し、浮き上がっている側のファスナーを優しく引っ張りながら、歯を飛ばすようにします。スライダーを元に戻し、飛ばした箇所が直るまで繰り返します。

このテクニックは恒久的な修理です。ただし、このテクニックが損傷を引き起こす可能性があると感じられる場合は、スライダーを取り外して交換してください。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0