Use your finger or a spudger to press and connect the LiDAR sensor connector to the logic board.
To re-attach press connectors like this one, carefully align and press down on one side until it clicks into place, then repeat on the other side. Don't press down in the middle. If the connector is misaligned, the pins can bend, causing permanent damage.

-	[~~title~~] ~~Remove~~ the LiDAR sensor
-	[* ~~black~~] ~~Use~~ the ~~point of a spudger to pry up and disconnect~~ the ~~LiDAR sensor~~ connector.
+	[* red] Use your finger or a spudger to press and connect the LiDAR sensor connector to the logic board.
+	[* icon_note] To re-attach [guide\|25629\|press connectors\|stepid=70308\|new_window=true] like this one, carefully align and press down on one side until it clicks into place, then repeat on the other side. Don't press down in the middle. If the connector is misaligned, the pins can bend, causing permanent damage.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0

iPhone 16 Pro Max LiDAR Sensor tauschen

crwdns2935425:03crwdne2935425:0