iPhone 16 Pro Max LiDAR Sensor Installation

crwdns2931653:01crwdne2931653:0 Install the LiDAR sensor



• Lay the LiDAR sensor in its recess.
crwdns2913378:0crwdne2913378:0
crwdns2934285:0crwdne2934285:0
crwdns2934285:0crwdne2934285:0
crwdns2917038:0crwdne2917038:0
1024
crwdns2891542:0crwdne2891542:0 crwdns2934287:0crwdne2934287:0
crwdns2931653:02crwdne2931653:0

• Use a Phillips screwdriver to install the two screws securing the LiDAR sensor:
• One 1.6 mm‑long screw
• One 2.9 mm‑long screw
crwdns2913378:0crwdne2913378:0
crwdns2934285:0crwdne2934285:0
crwdns2934285:0crwdne2934285:0
crwdns2917038:0crwdne2917038:0
1024
crwdns2891542:0crwdne2891542:0 crwdns2934287:0crwdne2934287:0
crwdns2931653:03crwdne2931653:0
• Use your finger or a spudger to press and connect the LiDAR sensor connector to the logic board.
• To re-attach press connectors like this one, carefully align and press down on one side until it clicks into place, then repeat on the other side. Don't press down in the middle. If the connector is misaligned, the pins can bend, causing permanent damage.
crwdns2913378:0crwdne2913378:0
crwdns2934285:0crwdne2934285:0
crwdns2934285:0crwdne2934285:0
crwdns2917038:0crwdne2917038:0
1024
crwdns2891542:0crwdne2891542:0 crwdns2934287:0crwdne2934287:0

crwdns2862417:0crwdne2862417:0

Arthur Shi

crwdns2935283:001/03/18crwdne2935283:0

283,814 crwdns2915208:0crwdne2915208:0

crwdns2935297:0587crwdne2935297:0

crwdns2918514:0crwdne2918514:0: 47

• 
• 
• 

crwdns2935301:044crwdne2935301:0

crwdns2915084:0crwdne2915084:0

iFixit crwdns2935289:0iFixitcrwdne2935289:0

Staff

crwdns2931471:0121crwdne2931471:0

crwdns2935297:019,706crwdne2935297:0

crwdns2942557:0crwdne2942557:0

crwdns2942955:0crwdne2942955:0

crwdns2852917:0crwdne2852917:0