crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

How to Remove a Blob from an AnkerMake M5 3D Printer

crwdns2935423:0crwdne2935423:0

crwdns2935425:01crwdne2935425:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936321:0crwdne2936321:0
crwdns2931653:01crwdne2931653:0
How to Remove a Blob from an AnkerMake M5 3D Printer, Prepare to Remove Extruder Housing: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 How to Remove a Blob from an AnkerMake M5 3D Printer, Prepare to Remove Extruder Housing: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 How to Remove a Blob from an AnkerMake M5 3D Printer, Prepare to Remove Extruder Housing: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Prepare to Remove Extruder Housing

  • Press down on the black collar while pulling up on the PTFE tubing.

  • Using a 1.5mm hex wrench, remove the two screws on either side of the USB-C cable.

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0