crwdns2935425:04crwdne2935425:0
crwdns2931653:04crwdne2931653:0
Clean Heater Block After Blob Has Melted Off
-
Plug the printer back in.
-
Power on the printer and heat the nozzle to 250°C for a few minutes to soften the blob. In many cases, the heat will melt off the blob if the extruder housing is removed.
crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0