crwdns2933423:0crwdne2933423:0

Sostituzione del joystick del controller wireless Xbox serie X/S

crwdns2936315:0crwdne2936315:0
crwdns2936321:0crwdne2936321:0
crwdns2931653:024crwdne2931653:0
Xbox Series X/S Wireless Controller Joystick Replacement, Clean the motherboard: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 Xbox Series X/S Wireless Controller Joystick Replacement, Clean the motherboard: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
Clean the motherboard
  • Secure the motherboard so you can access both sides of it.

  • Use the soldering iron to heat one side of a through-hole.

  • Use a desoldering pump on the opposite side of the through-hole to suck up any remaining solder.

  • Don't heat the through-hole continuously for longer than 15 seconds at a time to avoid damaging the pad.

  • If needed, use solder wick to remove any residual solder.

  • Repeat this for all through-holes and both sides of the motherboard.

Utilizzare il saldatore per riscaldare un foro passante sul circuito stampato.

Utilizzare una pompa dissaldante per aspirare eventuali residui di saldatura dal foro passante.

Per pulire i fori passanti, riscaldare da un lato e utilizzare la pompa dissaldante per aspirare il foro dall'altro lato.

Per rimuovere i residui di saldatura si può anche utilizzare una treccia dissaldante.

Ripetere l'operazione per tutti i fori passanti e per entrambi i lati del circuito stampato.

-[title] Clean the circuit board
-[* black] Use your soldering iron to heat up a through-hole on the circuit board.
-[* black] Use a desoldering pump to suck up any solder residue from the through-hole.
- [* icon_note] To clear out through-holes, heat it from one side and use the desoldering pump to suck through the hole from the other side.
-[* icon_note] You can also use solder wick instead to remove the residual solder.
-[* black] Repeat this for all through-holes and both sides of the circuit board.
+[title] Clean the motherboard
+[* black] Secure the motherboard so you can access both sides of it.
+[* black] Use the soldering iron to heat one side of a through-hole.
+[* black] Use a desoldering pump on the opposite side of the through-hole to suck up any remaining solder.
+ [* icon_caution] Don't heat the through-hole continuously for longer than 15 seconds at a time to avoid damaging the pad.
+[* black] If needed, use solder wick to remove any residual solder.
+[* black] Repeat this for all through-holes and both sides of the motherboard.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0