crwdns2933423:0crwdne2933423:0

iPhone 16 Plus Mikrofon entfernen

crwdns2931527:0crwdnd2931527:0crwdnd2931527:0crwdnd2931527:0crwdne2931527:0

crwdns2935425:03crwdne2935425:0

crwdns2936315:0crwdne2936315:0
crwdns2936319:0crwdne2936319:0
crwdns2931653:03crwdne2931653:0
iPhone 16 Plus Microphone Removal, Remove the microphone: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 iPhone 16 Plus Microphone Removal, Remove the microphone: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 iPhone 16 Plus Microphone Removal, Remove the microphone: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Remove the microphone
  • The microphone is held in place by strong adhesive to the bottom edge of the phone.

  • Don't pry against the battery, it could catch fire if damaged.

  • Insert the flat end of a spudger under the top edge of the microphone and pry up until you can grab it with your fingers.

  • If the microphone does not budge, try adding a little bit of heat using an iOpener, hair dryer, or heat gun. Only heat it it's slightly hot to touch, as the battery is susceptible to heat damage.

  • Peel the microphone from the adhesive securing it to the frame and remove it.

  • During reassembly, if your replacement part doesn't include adhesive, use thin, double-sided tape instead. Make sure it doesn't block the sound cutouts during installation.

Das Mikrofon ist stark mit der Unterkante des Smartphones verklebt.

Heble nicht gegen den Akku. Wenn er beschädigt ist, könnte er in Brand geraten.

Setze das flache Ende des Spudgers unter die Oberkante des Mikrofons und heble es soweit hoch, dass du es mit den Fingern fassen kannst.

Wenn sich das Mikrofon nicht leicht bewegen lässt, dann erwärme es mit einem iOpener, einem Haartrockner oder einem Heißluftgebläse. Erwärme nur so weit, dass du es kaum noch anfassen kannst, der Akku ist sehr hitzeempfindlich.

Löse das Mikrofon aus der Klebeverbindung zum Rahmen und entferne es.

Wenn dein Ersatzteil nicht mit Klebeband versehen ist, dann verwende stattdessen dünnes, doppelseitiges Klebeband. Achte darauf, dass es nicht die Öffnungen für den Ton blockiert.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0