crwdns2933423:0crwdne2933423:0

Roborock S7 Laser-Abstandssensor tauschen

crwdns2936315:0crwdne2936315:0
crwdns2936319:0crwdne2936319:0
crwdns2931653:06crwdne2931653:0
Roborock S7: Laser Distance Sensor Replacement, Removing the rubber band between the motor and the LDS: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Roborock S7: Laser Distance Sensor Replacement, Removing the rubber band between the motor and the LDS: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Roborock S7: Laser Distance Sensor Replacement, Removing the rubber band between the motor and the LDS: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Removing the rubber band between the motor and the LDS
  • If you're planning on replacing or cleaning the LDS' motor, follow the following steps.

  • Simply remove the rubber band connecting the LDS and the motor.

  • Do not stretch it out. It is flexible, but if you leave it stretched out, it will permanently deform.

Wenn du den Motor des LDS reinigen oder austauschen möchtest, folge diesen Schritten:

Entferne einfach den Gummiriemen zwischen LDS und Motor.

Dehne ihn nicht aus. Er ist zwar elastisch, kann aber leicht dauerhaft verformt werden.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0