便携式电站 UI 板拆卸

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:05crwdnd2931529:0crwdne2931529:0

crwdns2935425:03crwdne2935425:0

crwdns2936315:0crwdne2936315:0

crwdns2936311:0crwdne2936311:0

crwdns2931653:03crwdne2931653:0

Remove the main board supports

Flip your power station over.
Use a Phillips screwdriver to remove the four 6 mm‑long screws securing the two main board supports.
Hold the supports in place while removing the final screws. Otherwise, the support may swing onto the board and damage the small, surface‑mounted components.
Remove the main board supports.
During reassembly, make sure the beveled sides of the main board support screw holes face up.

拆除主板支架

翻转你的电站。
使用十字螺丝刀卸下固定两个主板支架的四颗 6 毫米长的螺丝。
卸下最后的螺钉时，请将支架固定到位。否则，支架可能会摆动到电路板上并损坏小型表面贴装元件。
移除主板支架。
重新组装时，确保主板支撑螺丝孔的斜面朝上。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0