便携式电站 UI 板拆卸

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:05crwdnd2931529:0crwdne2931529:0

crwdns2935425:02crwdne2935425:0

crwdns2936315:0crwdne2936315:0

crwdns2936311:0crwdne2936311:0

crwdns2931653:02crwdne2931653:0

Remove the front panel

Use your fingers to depress the two locking tabs holding the front panel in place.
Press on the clips themselves (just behind the front panel) and not through the cutouts on the top edge of the front panel.
While pressing the tabs down, push the front panel away from the chassis and remove it.
During reassembly:
Hook in the bottom edge of the front panel first, then push the top edge until it clicks into place.
Make sure the two USB-C ports slide into their cutouts in the front panel and aren't trapped underneath.

卸下前面板

用手指按下固定前面板的两个锁定片。
按下卡扣本身（就在前面板后面），而不是通过前面板顶部边缘的切口。
按下卡舌的同时，将前面板推离底盘并将其取下。
重新组装期间：
先将前面板的底部边缘钩住，然后推顶部边缘，直至其卡入到位。
确保两个 USB-C 端口滑入前面板上的切口中，并且不会被夹在下面。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0