crwdns2933423:0crwdne2933423:0

DualSense Edge フロントトリムの交換

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:017crwdnd2931529:0crwdne2931529:0

crwdns2935425:01crwdne2935425:0

crwdns2936315:0crwdne2936315:0
crwdns2936323:0crwdne2936323:0
crwdns2931653:01crwdne2931653:0
DualSense Edge Front Trim Replacement, Remove the front trim: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 DualSense Edge Front Trim Replacement, Remove the front trim: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 DualSense Edge Front Trim Replacement, Remove the front trim: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Remove the front trim
  • Place the controller on a work surface with the joysticks facing down.

  • Use a spudger or your finger to slide the Release tab to the left. The front trim should fall to the table.

  • If the front trim doesn't fall open, make sure the front trim has room to fall down and the Release tab is pushed all the way to the left.

  • Lift the controller up, leaving the front trim on the table.

  • During reassembly, insert the front trim at an angle so the top slots in first, then lower the trim into place and snap it onto the controller.

コントローラーのジョイスティックを下に向けた状態で作業面に置きます。

スパッジャーまたは指を使って、リリースタブを左にスライドさせます。フロントトリムがテーブルに落ちるはずです。

フロントトリムが落ちない場合は、フロントトリムが落ちるだけのスペースの余裕があることを確認し、リリースタブが左に完全に押されていることを確認してください。

フロントトリムをテーブルに残したまま、コントローラーを持ち上げます。

再組み立ての際には、フロントトリムを斜めに挿入し、上部のスロットを最初に挿入し、次にトリムを下げて所定の位置に収め、コントローラにカチッと音がするまで押し込みます。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0