DualSense Edge Front Trim Replacement

crwdns2931653:01crwdne2931653:0 Remove the front trim




• Place the controller on a work surface with the joysticks facing down.
• Use a spudger or your finger to slide the Release tab to the left. The front trim should fall to the table.
• If the front trim doesn't fall open, make sure the front trim has room to fall down and the Release tab is pushed all the way to the left.
• Lift the controller up, leaving the front trim on the table.
• During reassembly, insert the front trim at an angle so the top slots in first, then lower the trim into place and snap it onto the controller.
crwdns2913378:0crwdne2913378:0
crwdns2934285:0crwdne2934285:0
crwdns2934285:0crwdne2934285:0
crwdns2917038:0crwdne2917038:0
1024
crwdns2891542:0crwdne2891542:0 crwdns2934287:0crwdne2934287:0

crwdns2862417:0crwdne2862417:0

Spencer Pennington

crwdns2935283:009/09/23crwdne2935283:0

18,184 crwdns2915208:0crwdne2915208:0

crwdns2935297:0114crwdne2935297:0

crwdns2918514:0crwdne2918514:0: 33

• 
• 
• 

crwdns2935301:030crwdne2935301:0

crwdns2915084:0crwdne2915084:0

iFixit crwdns2935289:0iFixitcrwdne2935289:0

Staff

crwdns2931471:0121crwdne2931471:0

crwdns2935297:019,806crwdne2935297:0

crwdns2942557:0crwdne2942557:0

crwdns2942955:0crwdne2942955:0

crwdns2852917:0crwdne2852917:0