crwdns2933423:0crwdne2933423:0

はんだ付けとはんだ除去の作業ガイド

crwdns2935425:014crwdne2935425:0

crwdns2936315:0crwdne2936315:0
crwdns2936323:0crwdne2936323:0
crwdns2931653:014crwdne2931653:0
How To Solder and Desolder Connections: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0
  • To solder the new leads to the board, place the bare end of one lead onto the bead of solder on its corresponding solder pad.

  • Press the tip of the soldering iron onto the solder bead until it melts.

  • Slide the exposed end of the lead into the liquid solder until it is in the center of the bead, then remove the soldering iron.

  • Continue with the other connections the same way, taking special care not to solder two of the pads together.

新しいリードを基板にはんだ付けするには、対応するはんだパッドのはんだの玉に、被覆が剥がれているリードを当てます。

はんだごての先端を、はんだの玉に押し当てて溶かします。

露出したリードの端部を液体化したはんだに差し込み、はんだの玉の中心までスライドさせてから、はんだごてを離します。

隣接する2つのパッドをはんだで接続してしまわないように、慎重に他の接点にも同じ方法で作業を行います。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0