crwdns2933423:0crwdne2933423:0

はんだ付けとはんだ除去の作業ガイド

crwdns2936315:0crwdne2936315:0
crwdns2936323:0crwdne2936323:0
crwdns2931653:011crwdne2931653:0
How To Solder and Desolder Connections, Advanced Guide: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0
Advanced Guide
  • For the last section, battery leads will be soldered to surface-mount solder pads. These type of joints are harder to solder because the lead has no solid anchor point (such as a thru-hole) to hold it in place during soldering.

  • To de-solder the joint, place a solder wick on top of the existing solder ball and press down on the solder wick with the soldering iron.

  • Once the solder melts and flows into the wick, remove the wick from the joint.

  • Repeat the same procedure on the remaining leads.

  • When a section of solder wick is saturated with solder, it should be trimmed and discarded.

最後のセクションでは、バッテリーのリードを表面実装はんだパッドにはんだ付けします。このような種類の接合部は、はんだ付けの間にリードを正しい位置に固定するアンカーポイント(スルーホールなど)がないため、はんだ付けが難しくなります。

接合部のはんだを除去するには、はんだ吸い取り線を既存のはんだボールの上に当て、はんだごてで押し付けます。

はんだが溶けて吸い取り線に染み込んだら、吸い取り線を接合部から離します。

残りのリードにも同じ手順を繰り返します。

はんだ吸い取り線がはんだを吸い取れなくなったら、その部分をカットして捨てます。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0