crwdns2933423:0crwdne2933423:0

はんだ付けとはんだ除去の作業ガイド

crwdns2936315:0crwdne2936315:0
crwdns2936323:0crwdne2936323:0
crwdns2931653:04crwdne2931653:0
How To Solder and Desolder Connections: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0
  • Prepare your component for soldering by removing any excess solder from the contacts. The contacts should be clean enough to pass through the solder pad holes.

  • Run the soldering iron tip down the lengths of each contact to wipe the solder away from the component. Clean the iron's tip between strokes by wiping it against a moist sponge.

  • Excessive heat will damage the components, so do not apply the soldering iron to the component for long amounts of time.

部品の端子から余分なはんだを完全に除去して、はんだ付けを行う準備をします。端子は、はんだパッドのホールを通過できる程度にきれいにしておく必要があります。

はんだごての先端を、それぞれの端子の長手方向になぞらせて、はんだを部品から除去します。1回なぞるごとに、湿ったスポンジに押し当ててぬぐい、はんだごての先端の汚れを取ります。

加熱しすぎると部品が損傷するため、長時間はんだごてを部品に当てないでください。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0