crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

Reemplazo del conjunto de máquina de hielo del refrigerador Samsung

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936331:0crwdne2936331:0
crwdns2931653:03crwdne2931653:0
Samsung Older French Door Refrigerator Upper Icemaker Assembly Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Samsung Older French Door Refrigerator Upper Icemaker Assembly Replacement: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Samsung Older French Door Refrigerator Upper Icemaker Assembly Replacement: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0

  • Slide the cable cover out toward the front of the ice room by pulling the front edge.

  • Make sure to slide the cover out to the front and don't try to pull it sideways as you might break the tabs which secure the rear of the cover.

  • During reassembly, take your time and make sure to slide this part in until it goes back flush. Take care not to break the tabs. Check that the screw holes align and all the tabs show in the pockets on the cover and the entire edge of the cover is flush.

La configuración exacta de los conectores puede variar en tu refrigerador.

Desconecta el conector amarillo más a la izquierda:

Aprieta la pestaña de bloqueo con los dedos.

Mueve el conector suavemente de lado a lado para desconectarlo.

Utiliza los dedos o un destornillador para guiar el mazo de cables fuera de los clips de pared.

-[title] Disconnect the icemaker harness
-[* icon_note] The exact configuration of the connectors may vary on your refrigerator.
-[* black] Disconnect the left-most yellow connector:
- [* red] Squeeze the locking tab with your fingers.
- [* black] Rock the connector gently side to side to disconnect it.
-[* black] Use your fingers or a screwdriver to guide the wire harness out of the wall clips.
+[* black] Slide the cable cover out toward the front of the ice room by pulling the front edge.
+[* icon_caution] Make sure to ***slide*** the cover out to the front and don't try to pull it sideways as you might break the [link|https://guide-images.cdn.ifixit.com/igi/pkBlaKIEDJDKZM2t.full|tabs which secure the rear of the cover.|new_window=true]
+[* icon_reminder] During reassembly, take your time and make sure to ***slide*** this part in until it goes back flush. Take care not to break the [link|https://guide-images.cdn.ifixit.com/igi/pkBlaKIEDJDKZM2t.full|tabs|new_window=true]. Check that the screw holes align and all the tabs show in the pockets on the cover and the entire edge of the cover is flush.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0