crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

主板断线（屏幕）

crwdns2931527:0crwdnd2931527:0crwdnd2931527:0crwdnd2931527:0crwdne2931527:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936311:0crwdne2936311:0
crwdns2931653:06crwdne2931653:0
Motherboard Disconnection (Screen): crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Motherboard Disconnection (Screen): crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Motherboard Disconnection (Screen): crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0

  • Because of the awkward angle, this step requires some patience to avoid tearing the cables. Work slowly and apply heat regularly.

  • Use blunt nose tweezers to pull the cables away from their ZIF connectors slowly and steadily at a level angle to separate the coating.

  • Gripping the tweezers closer to the tip can help get a tighter hold on the cables.

  • Keep pulling on the cables until they're completely disconnected.

  • During reassembly:

  • Inspect the ends of the cables and the ZIF connectors for any remaining coating that could prevent a good connection.

  • Peel off the coating, heating the cable and the ZIF connectors when the coating becomes too brittle.

  • It doesn't have to look pretty! You just need to remove enough coating to have the cables sit properly in their connectors.

由于角度不合适，接下来的两个步骤需要一些耐心，以避免撕裂排线。 慢慢地工作并定期加热。

使用钝头镊子以水平角度缓慢而稳定地将排线从 ZIF 接口上拉开，以分离涂层。

将镊子靠近尖端握住可以帮助更紧地固定排线。

继续拉动排线，直到完全断开连接。

重新组装期间：

检查排线头部和 ZIF 接口是否有任何可能妨碍连接的残留涂层。

剥掉涂层——当涂层变得太脆时加热排线和 ZIF 接口。

不必力求完美！ 您只需去除足够的涂层即可将排线正确固定在接口中。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0