crwdns2933423:0crwdne2933423:0

Scollegamento scheda madre

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:02crwdnd2931529:0crwdne2931529:0

crwdns2936315:0crwdne2936315:0
crwdns2936321:0crwdne2936321:0
crwdns2931653:04crwdne2931653:0
Kobo Clara Colour Motherboard Disconnection: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Kobo Clara Colour Motherboard Disconnection: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Kobo Clara Colour Motherboard Disconnection: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
  • Grip the power button cable close to the head and pull it away from its ZIF connector slowly and steadily to separate the coating.

  • If the coating feels stubborn, reheat the connector and try again.

  • Keep pulling on the cable until it comes completely out of its socket.

  • During reassembly:

  • Inspect the head of the cable and the ZIF connector for any remaining coating that could prevent a good connection.

  • Peel off the coating—heating the cable and the ZIF connector when the coating becomes too brittle.

  • It doesn't have to look pretty! You just need to remove enough coating to have the cable sit properly in its connector.

Afferra il cavo del pulsante di accensione vicino alla sua testa e allontanalo dal suo connettore ZIF in modo lento e costante per separare il rivestimento.

Se il rivestimento sembra testardo, scalda di nuovo il connettore e riprova.

Continua a tirare il cavo finché non esce completamente dalla sua presa.

Durante il rimontaggio:

Ispeziona l'estremità del cavo e il connettore ZIF per cercare se è rimasto del rivestimento che potrebbe impedire il formarsi di una buona connessione.

Rimuovi il rivestimento, scalda il cavo e il connettore ZIF quando il rivestimento diventa troppo friabile.

Non deve essere bello da vedere! Devi solo rimuovere abbastanza rivestimento perché il cavo si posizioni correttamente nel suo connettore.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0