crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

마더보드 연결 해제

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:02crwdnd2931529:0crwdne2931529:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936325:0crwdne2936325:0
crwdns2931653:07crwdne2931653:0
Kobo Clara Colour Motherboard Disconnection, Disconnect the digitizer cable: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Kobo Clara Colour Motherboard Disconnection, Disconnect the digitizer cable: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Kobo Clara Colour Motherboard Disconnection, Disconnect the digitizer cable: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Disconnect the digitizer cable

  • Use blunt nose tweezers to grip the digitizer cable close to the head and pull it away from its ZIF connector slowly and steadily to separate the coating.

  • If the coating feels stubborn, reheat the connector and try again.

  • Keep pulling on the cable until it comes completely out of its socket.

  • During reassembly:

  • Inspect the head of the cable and the ZIF connector for any remaining coating that could prevent a good connection.

  • Peel off the coating—heating the cable and the ZIF connector when the coating becomes too brittle.

  • It doesn't have to look pretty! You just need to remove enough coating to have the cable sit properly in its connector.

디지타이저 케이블 분리하기

무딘 핀셋을 사용하여 디지타이저 케이블을 머리에 가깝게 잡고 ZIF 커넥터에서 천천히 그리고 일정하게 당겨 코팅을 분리하세요.

코팅이 잘 벗겨지지 않으면 커넥터를 다시 가열한 후 다시 시도하세요.

케이블이 소켓에서 완전히 빠질 때까지 계속 당기세요.

재조립할 때:

케이블 헤드와 ZIF 커넥터의 연결 상태를 방해할 수 있는 코팅이 남아 있는지 검사하세요.

코팅이 너무 부스러지면 케이블과 ZIF 커넥터를 가열하여 코팅을 벗겨내세요.

예쁘게 보일 필요는 없습니다! 케이블이 커넥터에 제대로 장착될 수 있을 만큼만 코팅을 벗겨내면 됩니다.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0