crwdns2933423:0crwdne2933423:0

Asus ROG Ally Battery Mod

crwdns2936315:0crwdne2936315:0
crwdns2936325:0crwdne2936325:0
crwdns2931653:06crwdne2931653:0
Asus ROG Ally Battery Mod, Prepare your 3D printed backplate: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Asus ROG Ally Battery Mod, Prepare your 3D printed backplate: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Asus ROG Ally Battery Mod, Prepare your 3D printed backplate: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Prepare your 3D printed backplate
  • It's a good idea to run pilot holes through any screw pillars before proceeding further.

  • Make sure to grab the light blocker from the original back cover and place it in the new shell.

  • This piece of foam covers a light sensor on the ROG Ally mainboard. If the sensor is not covered, the system will not boot.

  • Transfer the paddles and triggers from the original cover over to the newly printed back plate.

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0