crwdns2935355:0devicecrwdnd2935355:0crwdnd2935355:0crwdne2935355:0
crwdns2935335:0crwdne2935335:0
crwdns2935381:0crwdne2935381:0
crwdns2936071:01crwdne2936071:0 — Remove the ear pad from the left cup
Use a plastic card to remove the ear pad from the left cup. Slide the card into the slot and make a rotating motion.
crwdns2936071:02crwdne2936071:0 — Remove the screws
Remove the fabric cover and remove the four screws using a Torx TR6 screwdriver.
crwdns2936071:03crwdne2936071:0 — Disconnect the cable and remove battery
Carefully disconnect the flex cable.
crwdns2936071:04crwdne2936071:0 — Remove battery
The battery is glued to the case. Use a knife to carefully cut off the battery. Take care not to damage the battery!
crwdns2936071:05crwdne2936071:0 — Remove the shell from the battery.
Remove the shell from the old battery.
crwdns2936071:06crwdne2936071:0 — Remove the controller from the old battery
Cut the controller from the old battery.
crwdns2936071:07crwdne2936071:0 — Remove the controller from the new battery
Cut the controller from the new battery.
crwdns2936071:08crwdne2936071:0 — Solder the new battery to the old controller
Solder the new battery to the old controller. Observe the polarity!
crwdns2936071:09crwdne2936071:0 — Wake up the controller
Measure the voltage at the controller pins. You will most likely get 0 volts. It is necessary to wake up the controller.
crwdns2936071:010crwdne2936071:0 — Attach the controller
Attach the controller to the battery with tape.
crwdns2936071:011crwdne2936071:0 — Solder the battery
Solder the battery. Use heat shrink tubing or duct tape to insulate the soldering area.
crwdns2936071:012crwdne2936071:0 — Place the battery in the bottom of the cup
Place the battery in the bottom of the cup.
crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0