crwdns2935355:0devicecrwdnd2935355:0crwdnd2935355:0crwdne2935355:0
crwdns2935335:0crwdne2935335:0
crwdns2935381:0crwdne2935381:0
crwdns2936071:01crwdne2936071:0 — Preparation
Never forget: Remove the cable from the powerplug
crwdns2936071:02crwdne2936071:0 — Remove the backside
The backside is fixed with seven Torx T10 screws. Unscrew them
crwdns2936071:03crwdne2936071:0 — Remove the powder compartment lid
Pull the powder compartment up.
crwdns2936071:04crwdne2936071:0 — Loosen the upper housing part
In the powder compartment, you should see a rubber cover. Loosen the rubber cover with the appropriate tools.
crwdns2936071:05crwdne2936071:0 — loosening the Upper housing part
The upper cover with the brewing unit is held up from three clamps. These can be reached through a slit.
crwdns2936071:06crwdne2936071:0 — Removal of the upper case
On the side that has a a watertank you can find 2 other clamps
crwdns2936071:07crwdne2936071:0 — Removal of the side panel
Push the right and the left side panel back, then pull the lower edge out and pull the side panel out.
crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0